Home > News > Plate heat exchanger...
Plate heat exchanger installation
Source: Time: 2020-05-29 10:33:39 Hit:
Are you curious about the installation process of the blackboard heat exchanger? In fact, the plate heat exchanger is a form of heat exchanger, and the installation method is similar. Let you understand the installation introduction of the plate heat exchanger in two steps.The installation process we want to do is mainly to ensure that the internal structure can meet the user's technological needs.
We all know that the structure of the plate heat exchanger is composed of various components such as upper and lower guide rods, movable compression plates, fastening screws, clamping screws, front struts, fixed compression plates, and legs. All we have to do is to connect the equipment to the overall process system in a fixed form, and make sure that no short-circuits, current interruptions, trips, etc. will occur during the later operation of the equipment.
Specific installation steps:
1. Clean the inside of the equipment to ensure that no impurities are present.2. Stick the gasket to the plate, fix it, and stick it for about one day.
3. Put the plates into the equipment in the specified order to ensure that the flow direction of the medium is not wrong. During installation, ensure that the installation is parallel and the inclination cannot be higher than 45 °.
4. Close the compression plate to ensure that the equipment will not be biased. Use a wrench to tighten the compression bolt.
5. Carry out the overall pressure test process. After the pressure test, if the equipment can still run stably, the installation is complete.
YOJO is a heat exchanger manufacturer, and Jiangsu heat exchanger is in a leading position.If you want to know more about the installation process of plate heat exchanger, you can ask us.
Tag: Heat exchange equipment, plate heat exchanger installation, Jiangsu heat exchanger, Heat exchanger manufacturers
